As with all things worth doing in life, applying your lashes for the first time may take practice. If it feels hard at first, don’t give up! It takes most people a couple of applications before everything clicks.
Be patient with yourself and soon lash application will start to feel like second nature. For most customers, it only takes a few minutes per eye to put on a full set of lashes!
Clean your lashes with your favorite OIL FREE eye makeup remover or plain water.
Carefully remove LashLife segments from the lash tray. Gently insert your fuse wand under a lash segment and hold the segment as close to the base as possible. Pull the segment in an upward motion to release from the lash tray. Set your lashes down, ready for application.
NB* apply lashes from the inner to the outer corner of your eyes, following the arrows on the packaging
Work on one eye at a time. On the eye, you choose to start with, apply a small amount of LashLife glue to your lashes as you would mascara while focusing on the base of your lashes.
Do not apply to the tips of your lashes to avoid clumping.
Do not apply to your waterline/ tightline.
*Glue application method 2: use the tip of the glue applicator to dot a small amount of glue along the base of your lash line, 1-2mm away from your water line.
With your Applicator wand, hold just the tips of the lash segment so that most of the lash surface is exposed. Dab a tiny amount of glue to the top of the lash segment spine.
Continue adding more lashes. Apply lashes closely next to each other for a seamless look.
Depending on the size of your eye, you will use 5/4/3 lash segments per eye.
Once you’ve applied all of your segments, clean off the inside of the applicator with water/ micellar water/ rubbing alcohol.
Wait for 2 minutes for the glue to dry. Use the applicator to fuse your lashes. Gently clamp your natural lashes together with the LashLife segments.
Having trouble? Send us a WhatsApp message and we will be glad to help
If the lashes are sticking to your applicator when you are fusing them together, you may have gotten too much glue on the applicator. You can use a little water or rubbing alcohol to wipe
the applicator off and try again. You may also use your fingertips for this step. Use your thumb and middle finger to fuse lashes.
Make sure you are applying glue, not just on the spines of the segments, but also to the corners.
Remember, a little glue goes a long way
Soak lashes in rubbing alcohol for 1 hour.
We suggest using the Dischem brand, 91% rubbing alcohol. Do not use a lower concentration of alcohol as it will cause lashes to disintegrate.
Remove lashes from Alchol, 1 at a time and use a makeup brush or cotton bud to gently wipe away any glue residue.
Dip the cleaned lash in water and set on a paper towel to try.
Your lashes are now ready to be reused.
LashLife segments will eventually disintegrate after 2-3 uses